Internal Control Module Brake Signal Performance
An internal self-test in the control module reports a fault in its processing of the "brake signal" value. The module computes and cross-checks this value redundantly inside its own processor; when the results disagree, the code sets. It points to a hardware or software fault inside the module itself, not to a defect of the external sensor. Causes are an internal processor or memory fault, corrupted control-module software, or low or disturbed module supply voltage.
Affected components
- Ecu internal processing
- Brake pedal switch
Common causes
- High likelihood: Internal software anomaly
Possible symptoms
- Check engine light on
- Possible limp mode or no-start
- Multiple follow-up faults across modules
- Reset/relearn may be needed after repair
Diagnostic notes
- The malfunction indicator lamp may illuminate
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.