PTO Speed Selector Sensor/Switch 1 Circuit Low
PTO speed selector 1 input reads stuck low — short to ground or analog signal pegged at minimum. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Affected components
- Pto speed selector 1
Common causes
- High likelihood: Switch wire shorted to ground
- Low likelihood: Connector pins corroded - high contact resistance
- Low likelihood: Harness chafing through insulation
Diagnostic notes
- The malfunction indicator lamp may illuminate
Related codes
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.