Ignition Output Start
Fault on the ignition START output — module cannot drive the starter solenoid via this line. A communication loss with this module breaks any function relying on its data — diagnostic tools may show 'no response' and dependent modules can fall into limp mode.
Affected components
- Ignition output
- Starter relay
Common causes
- High likelihood: Wiring or starter relay fault
- Low likelihood: Gateway module routing CAN messages incorrectly
- Low likelihood: CAN terminating resistor (120 Ω) drifted out of spec
Possible symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Diagnostic notes
- The malfunction indicator lamp may illuminate
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.