Brake Pedal Position Sensor Supply Voltage Circuit High
Brake pedal position sensor supply voltage above expected range. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Affected components
- Brake pedal sensor
- Sensor supply
Common causes
- High likelihood: Supply wire shorted to battery
- Low likelihood: Connector pins corroded - high contact resistance
- Low likelihood: Supply wire pinched against B+ source
Possible symptoms
- ABS warning light on
- ESC/stability control deactivated
- Possible reduced brake assist
- Speedometer may behave erratically
Diagnostic notes
- The malfunction indicator lamp may illuminate
- Reduced-power or limp mode may occur
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.