Fuel Pump Module B Control Circuit Low
Fuel pump module B control voltage below expected range. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Affected components
- Fuel pump module b
- Module wiring
Common causes
- High likelihood: Wiring shorted to ground
- Low likelihood: Connector pins corroded - high contact resistance
- Low likelihood: Harness chafing through insulation
Possible symptoms
- Check engine light on
- Hard start, no start, or stalling under load
- Power loss especially at high load or rpm
- Possible long cranking time
Diagnostic notes
- The malfunction indicator lamp may illuminate
- This code can affect emissions
- Reduced-power or limp mode may occur
Related codes
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.