High Voltage System Interlock Circuit Low
The HV interlock signal is below threshold, indicating broken loop or short to ground. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Affected components
- Hv interlock loop
- Hv service connector
Common causes
- High likelihood: Interlock loop broken
- Low likelihood: Connector pins corroded - high contact resistance
- Low likelihood: Harness chafing through insulation
Diagnostic notes
- The malfunction indicator lamp may illuminate
- Reduced-power or limp mode may occur
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.