Generator Position Sensor Circuit A Circuit High
The generator position sensor channel A reports a circuit high fault. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Affected components
- Generator position sensor a
- Wiring harness
- Hybrid control module
Common causes
- High likelihood: Signal wire shorted to B+
- Medium likelihood: Open sensor
- Low likelihood: Connector pins corroded - high contact resistance
Diagnostic notes
- The malfunction indicator lamp may illuminate
- Reduced-power or limp mode may occur
Related codes
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.