Auxiliary Ignition Switch On/Start Position Circuit High
Auxiliary ignition switch On/Start input reads stuck high — short to battery voltage. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Affected components
- Auxiliary ignition switch
- Wiring harness
Common causes
- High likelihood: Wire shorted to battery voltage
- Low likelihood: Connector pins corroded - high contact resistance
- Low likelihood: Supply wire pinched against B+ source
Diagnostic notes
- The malfunction indicator lamp may illuminate
Related codes
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.