B Camshaft Position Actuator Temperature Sensor Circuit Low Bank 2
Cam actuator B temperature sensor on bank 2 signal voltage below expected range. The camshaft position sensor identifies which cylinder is on the compression stroke — without it the ECM cannot run sequential injection or coil-on-plug ignition correctly.
Affected components
- Cam actuator b temp sensor b2
- Sensor wiring
Common causes
- High likelihood: Signal wire shorted to ground
- Low likelihood: Connector pins corroded - high contact resistance
- Low likelihood: Harness chafing through insulation
Possible symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Diagnostic notes
- The malfunction indicator lamp may illuminate
- This code can affect emissions
Related codes
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.