Lost Communication with Fuel Pump Control Module
The Fuel Pump Control Module has stopped transmitting on the vehicle data bus, so other control units no longer receive its messages. Fuel-delivery control is lost, which can starve the engine of fuel. Typical causes are loss of power or ground at the module, an open or shorted CAN/LIN bus wire, a connector fault, or an internal module failure.
Affected components
- Fuel pump control module
- Can bus wiring
Common causes
- High likelihood: Fuel pump module unpowered (often a fuse or relay)
- Medium likelihood: CAN wiring to FPCM broken
- Low likelihood: Gateway module routing CAN messages incorrectly
Possible symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Diagnostic notes
- The malfunction indicator lamp may illuminate
- This code can affect emissions
- Reduced-power or limp mode may occur
Sources
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.